Measurement Specialties 9116 Manual de usuario descargar pdf (Pagina 101)

Measurement Specialties Inc. Model 9116 User’s Manual

Page 89 www.MEAS-SPEC.com

RE-BOOT MODULE (UDP/IP Command ‘psireboot’)

Purpose: To unconditionally “reboot” a specified module.

Command

“psireboot ethadr”

where ethadr is the Ethernet address of the specified module in the

following special hex-digit format

‘xx-xx-xx-xx-xx-xx’

Response

none (module reboots)

Description: When a Model 9116 module receives this broadcast command, (by continuously

monitoring port 7000) it responds by immediately restarting its firmware. The

result is essentially the same as a power-up restart, in that any TCP/IP

connection is lost, and the module returns to its normal startup state. The host

must wait long enough for the re-boot process to be completed before it can

again request a connection to the module.

Example:

● Re-boot a specified module on the network.

“psireboot 00-E0-8D-00-00-01”

Response:

(None)

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 145 146

Sin comentarios

Measurement Specialties 9116 Manual de usuario Pagina 101