Measurement Specialties 9116 Manual de usuario descargar pdf (Pagina 96)

Measurement Specialties Inc. Model 9116 User’s Manual

Page 84 www.MEAS-SPEC.com

Description

‘q’ read

index

Set Cal Valves to RUN or LEAK Position (default)

— choice made by ii=12.

Set Cal Valves to CAL/RE-ZERO or PURGE Position —

choice made by ii=12.

see chart

below

0D-0E

Reserved for factory use

Disable periodic Thermal Coefficient Update task.

Enable periodic Thermal Coefficient Update task (default).

01-20

Set Number of A/D Samples to Average, (default = 8).

Valid values are 4, 8,16, 32, and 64. Other values below 64

are rounded up to the next valid value listed above.

Reserved for factory use

Set Cal Valves to RUN or CAL/RE-ZERO Position (default)

— choice made by ii=0C.

Set Cal Valves to PURGE or LEAK Position — choice made

by ii=0C.

see chart

below

Use Static IP Address Resolution (default)

Use Dynamic IP Address Resolution (RARP/BOOTP)

(Results in immediately becoming the module’s new power-on

default)

Disable Host Response/Stream Back-Off Delay (default).

Enable Host Response/Stream Back-Off Delay as low-order

byte of Ethernet Address(converted to decimal value * 20

Enable Host Response/Stream Back-Off Delay specified

per eeee

Disable Host Response/Stream Total Size Prefix (default).

Enable Host Response/Stream Total Size Prefix (2-byte

big-endian binary value with total size of response or stream

data in bytes that follows it).

Set TCP Connect Port per eeee as decimal value

(default=9000).

Disable Auto UDP Broadcast at Reset (default).

Enable Auto UDP Broadcast at Reset.

Set Minimum Temperature Alarm Set Point (in

per eeee as decimal value (default = 0

C).

Set Maximum Temperature Alarm Set Point ( in

per eeee as decimal value (default = 60

C).

Set Thermal Update Scan Interval per eeee as decimal

value (seconds), 1 <= eeee <= 3600 seconds (default = 15).

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 145 146

Comentarios a estos manuales

Sin comentarios

Measurement Specialties 9116 Manual de usuario Pagina 96

Comentarios a estos manuales